Country Flags IBS Electronics USA IBS Electronics Mexico IBS Electronics Philippines IBS Electronics China IBS Electronics Malaysia IBS Electronics India IBS Electronics Hong Kong IBS Electronics Singapore
Home > Resistors > Wirewound Resistors > Wirewound Resistor 0.01 Ohm 5W 10% Axial

Wirewound Resistor 0.01 Ohm 5W 10% Axial

Be the first to review this product

Availability: In stock

Only 13 left

$0.7500
OR

Quick Overview

Wirewound Ww - 5W,10%, 0.01 Ohm Resistor 57R19-1

Wirewound Resistor 0.01 Ohm 5W 10% Axial

Double click on above image to view full picture

Zoom Out
Zoom In

More Views

Details

57R19-1 Wirewound Resistor 0.01 Ohms 5W 10% Axial Through Hole

The construction of this type of resistor is also very simple. In wire wound resistor a wire of manganin or constantan is wound around a cylinder of insulated material. The temperature coefficient of resistance of these two materials is almost zero. So there would no resistance variation with temperature. The wounded wire is covered with an insulating material such as baked enamel. This cover of insulating heat resistible material is provided to resist the effect of ambient temperature variation. Different sizes and ratings of wire wound resistor can easily be achieved by using different lengths and diameters of the wire. These resistors are easily available for wide range of ratings. The range of resistance values varies from 1 Ω to 1 MΩ. Typical tolerance limit of these resistors varies from 0.01 % to 1 %. They can be used for high power applications of 5 to 200 W dissipation ratings. The cost of these resistors is much higher than carbon resistor. Normally wire wound resistor is used where carbon composition resistor cannot meet the purpose because of its limitations.

Additional Information

57R19-1
© 1994 - 2019 IBS Electronics Inc. All rights Reserved.    •    Call Now: 1-800-717-6475     Go to Top  Go to Top of Page