Country Flags IBS Electronics USA IBS Electronics Mexico IBS Electronics Philippines IBS Electronics China IBS Electronics Malaysia IBS Electronics India IBS Electronics Hong Kong IBS Electronics Singapore
Home > Electromechanical > Hardware > Screws & Fasteners > Hardware 620013 POP RIVET AD43H 1/8" X .377"

Hardware 620013 POP RIVET AD43H 1/8" X .377"

Be the first to review this product

Availability: In stock

Only 855 left

$0.1500
  • Buy 10 for $0.1300 each and save 14%
  • Buy 50 for $0.1100 each and save 27%
  • Buy 100 for $0.0900 each and save 40%
  • Buy 500 for $0.0700 each and save 54%
  • Buy 1000 for $0.0500 each and save 67%
  • Buy 2000 for $0.0300 each and save 80%
OR

Quick Overview

Rivet - Pop Rivet Ad43H 1/8 X .3 77 620013

Hardware 620013 POP RIVET AD43H 1/8" X .377"

Double click on above image to view full picture

Zoom Out
Zoom In

More Views

Details

620013 POP® Rivets AD43H 1/8" X .377"

POP rivets are used in a numerous applications to secure two or more components together. Typically used in sheet type products, the POP rivet is easily installed with access only required from one side of the assembly.

A rivet is a permanent mechanical fastener. Before being installed, a rivet consists of a smooth cylindrical shaft with a head on one end. The end opposite the head is called the tail. On installation the rivet is placed in a punched or drilled hole, and the tail is upset, or bucked (i.e., deformed), so that it expands to about 1.5 times the original shaft diameter, holding the rivet in place. In other words, pounding creates a new "head" on the other end by smashing the "tail" material flatter, resulting in a rivet that is roughly a dumbbell shape. To distinguish between the two ends of the rivet, the original head is called the factory head and the deformed end is called the shop head or buck-tail.

To fasten the rivet, the end of the shank is impacted, pressed or spun after the rivet has been inserted into a work-piece.  A solid head is formed (upset) to create the clinched head of the rivet. When impact or press clinched, the force required to form the clinched head of the rivet swells the entire shank of the rivet to completely fill the work-piece hole.  Swelling of the shank occurs most by the clinched head end of the rivet.  Spun/orbital/radial rivet clinches require less tonnage to form than impact or pressed rivets; therefore, do not have the same shank swelling capability.  Pre-punched or drilled work-piece holes are required for use on most solid rivet applications.

Additional Information

H1052
H1052
© 1994 - 2019 IBS Electronics Inc. All rights Reserved.    •    Call Now: 1-800-717-6475     Go to Top  Go to Top of Page