Country Flags IBS Electronics USA IBS Electronics Mexico IBS Electronics Philippines IBS Electronics China IBS Electronics Malaysia IBS Electronics India IBS Electronics Hong Kong IBS Electronics Singapore
Home > ICs > Discrete Semiconductors > Operational Amplifiers - Op Amps > Texas Instruments TL054CN IC Quad Op-Amp 8.4mA 2.7MHZ DIP-14

Texas Instruments TL054CN IC Quad Op-Amp 8.4mA 2.7MHZ DIP-14

Be the first to review this product

Availability: In stock

Only 600 left

$2.2500
  • Buy 10 for $1.4000 each and save 38%
  • Buy 50 for $1.0000 each and save 56%
  • Buy 100 for $0.9000 each and save 60%
  • Buy 500 for $0.8000 each and save 65%
  • Buy 1000 for $0.7000 each and save 69%
  • Buy 2000 for $0.6000 each and save 74%
OR

Quick Overview

TL054CN Texas Instruments Precision Amplifiers Enhanced Prec Q J-FET Amplifier 4 Circuit 14-PDIP

Texas Instruments TL054CN IC Quad Op-Amp  8.4mA 2.7MHZ DIP-14

Double click on above image to view full picture

Zoom Out
Zoom In

More Views

Details

Texas Instruments TL054CN Quad Enhanced JFET Precision Operational Amplifier 8.4mA DIP-14 Through Hole
Direct Upgrades to TL07x and TL08x BiFET Operational Amplifiers Faster Slew Rate (20 V/µs Typ) Without Increased Power Consumption

On-Chip Offset-Voltage Trimming for Improved DC Performance and Precision Grades Are Available (1.5 mV, TL051A)

The TL05x series of JFET-input operational amplifiers offers improved dc and ac characteristics over the TL07x and TL08x families of BiFET operational amplifiers. On-chip Zener trimming of offset voltage yields precision grades as low mV (TL051A) for greater accuracy in dc-coupled applications. Texas Instruments improved BiFET process and optimized designs also yield improved bandwidth and slew rate without increased power consumption. The TL05x devices are pin-compatible with the TL07x and TL08x and can be used to upgrade existing circuits or for optimal performance in new designs. BiFET operational amplifiers offer the inherently higher input impedance of the JFET-input transistors, without sacrificing the output drive associated with bipolar amplifiers. This makes them better suited for interfacing with high-impedance sensors or very low-level ac signals. They also feature inherently better ac response than bipolar or CMOS devices having comparable power consumption. The TL05x family was designed to offer higher precision and better ac response than the TL08x, with the low noise floor of the TL07x. Designers requiring significantly faster ac response or ensured lower noise should consider the Excalibur TLE208x and TLE207x families of BiFET operational amplifiers. Because BiFET operational amplifiers are designed for use with dual power supplies, care must be taken to observe common-mode input voltage limits and output swing when operating from a single supply. DC biasing of the input signal is required, and loads should be terminated to a virtual-ground node at mid-supply. Texas Instruments TLE2426 integrated virtual ground generator is useful when operating BiFET amplifiers from single supplies. The TL05x are fully specified ±15 V and ±5 V. For operation in low-voltage and/or single-supply systems, Texas Instruments LinCMOS families of operational amplifiers (TLC-prefix) are recommended. When moving from BiFET to CMOS amplifiers, particular attention should be paid to the slew rate and bandwidth requirements, and also the output loading.

Additional Information

TL054CN
© 1994 - 2019 IBS Electronics Inc. All rights Reserved.    •    Call Now: 1-800-717-6475     Go to Top  Go to Top of Page